Voltage Drop Calculator

See the voltage across every resistor in a series circuit, the circuit current and the power each resistor dissipates.

V

Resistors in series

Circuit current 2 mA Total resistance 6 kΩ
Voltage drop across each resistor
Resistor Value Voltage drop Share Power
R11 kΩ2 V16.7%4 mW
R22 kΩ4 V33.3%8 mW
R33 kΩ6 V50%12 mW

How to use the voltage drop calculator

Enter the supply voltage, then the value of every resistor in the series string. The calculator shows the current flowing round the circuit and a table with the voltage across each resistor, its share of the supply and the power it dissipates.

How to calculate the voltage drop across a resistor

For a single resistor with a known current, it is simply Ohm’s law:

Vdrop = I × R

In a series circuit, first find the current from the total resistance, then apply Ohm’s law to each resistor:

  1. Add up the resistors: Rtotal = R1 + R2 + R3 + …
  2. Find the current: I = Vsupply / Rtotal
  3. Multiply that current by each resistor: V1 = I × R1, V2 = I × R2, and so on.

A shortcut gives the same answer: each resistor’s drop is the supply times its share of the total resistance, V1 = Vsupply × R1 / Rtotal.

Worked example

A 12 V supply with 1 kΩ, 2 kΩ and 3 kΩ in series:

  • Rtotal = 6 kΩ, so I = 12 / 6,000 = 2 mA
  • V1 = 0.002 × 1,000 = 2 V
  • V2 = 0.002 × 2,000 = 4 V
  • V3 = 0.002 × 3,000 = 6 V

The drops add up to 12 V, the supply voltage. This is Kirchhoff’s voltage law, and it is a handy check on any series calculation.

Voltage drop in parallel circuits

Resistors in parallel all have the same voltage across them, equal to the voltage across the whole group. To find it, combine the parallel group with the parallel resistor calculator, treat the result as one resistor in the series string here, and read off its drop.

Measuring voltage drop

Set a multimeter to DC volts and touch the probes to both ends of the resistor while the circuit is powered. Unlike resistance measurements, this works with the resistor still in place. If the measured drop is very different from the calculated one, check for a wrong resistor value, a poor connection or an unexpected load.

For a full step-by-step guide, read how to calculate voltage drop across a resistor.

Frequently asked questions

Why does a resistor drop voltage?

Pushing current through a resistance takes energy. The voltage drop is that energy per unit of charge, and it is turned into heat in the resistor.

Does the largest resistor have the largest voltage drop?

In a series circuit, yes. The current is the same through every resistor, so the drop is proportional to the resistance.

What is the difference between voltage and voltage drop?

Voltage is measured between any two points. Voltage drop is the voltage between the two ends of one component, the part of the supply it “uses up”.

More calculators