Ohm’s Law Calculator

Enter any two of voltage, current, resistance and power, and the calculator works out the other two.

Enter any two values. The other two are worked out for you.

From voltage and resistance
Voltage
12 V
Current
12 mA
Resistance
1 kΩ
Power
144 mW

How to use the Ohm’s law calculator

Fill in any two boxes and pick the units. The other two values appear below. If you fill in more than two, the calculator uses the two you changed most recently. Use Clear all to start again.

The Ohm’s law formula

Ohm’s law links the voltage across a resistor, the current through it and its resistance:

V = I × R

Rearranged, I = V / R and R = V / I. Add the power formula P = V × I and you can find any of the four values from any two.

You know Voltage V Current I Resistance R Power P
V and I – – V / I V × I
V and R – V / R – V² / R
V and P – P / V V² / P –
I and R I × R – – I² × R
I and P P / I – P / I² –
R and P √(P × R) √(P / R) – –

Worked examples

Current through a resistor

12 V across a 1 kΩ resistor: I = 12 / 1,000 = 0.012 A = 12 mA. The power is 12 × 0.012 = 0.144 W.

Resistance from a measurement

A heater draws 2 A from 24 V: R = 24 / 2 = 12 Ω, using 48 W.

Current from a power rating

A 1/4 W, 1 kΩ resistor can safely carry at most I = √(0.25 / 1,000) = 15.8 mA. In practice, stay well below that.

Watch the units

Most mistakes come from mixing units. Ohm’s law works directly in volts, amps and ohms. A current of 20 mA is 0.02 A, and 4.7 kΩ is 4,700 Ω. The unit menus in the calculator do this conversion, so you can enter values as they appear on a schematic.

Where Ohm’s law applies

Ohm’s law describes resistors very well, and wires and heating elements fairly well. It does not describe LEDs, diodes or transistors, whose current does not rise in proportion to voltage. That is why an LED needs a series resistor. See the LED resistor calculator. For several resistors at once, combine them first with the series or parallel calculator, or use the voltage drop calculator for a series string.

Frequently asked questions

What is Ohm’s law in simple terms?

The current through a resistor rises in step with the voltage across it. Double the voltage and the current doubles. The resistance sets how much current you get for each volt.

How do you calculate the current through a resistor?

Divide the voltage across the resistor by its resistance: I = V / R. Our guide on calculating the current through a resistor goes through series and parallel circuits step by step.

Who discovered Ohm’s law?

The German physicist Georg Simon Ohm published it in 1827. The unit of resistance, the ohm (Ω), is named after him.

More calculators