Voltage Drop Calculator
See the voltage across every resistor in a series circuit, the circuit current and the power each resistor dissipates.
How to use the voltage drop calculator
Enter the supply voltage, then the value of every resistor in the series string. The calculator shows the current flowing round the circuit and a table with the voltage across each resistor, its share of the supply and the power it dissipates.
How to calculate the voltage drop across a resistor
For a single resistor with a known current, it is simply Ohm’s law:
Vdrop = I × R
In a series circuit, first find the current from the total resistance, then apply Ohm’s law to each resistor:
- Add up the resistors: Rtotal = R1 + R2 + R3 + …
- Find the current: I = Vsupply / Rtotal
- Multiply that current by each resistor: V1 = I × R1, V2 = I × R2, and so on.
A shortcut gives the same answer: each resistor’s drop is the supply times its share of the total resistance, V1 = Vsupply × R1 / Rtotal.
Worked example
A 12 V supply with 1 kΩ, 2 kΩ and 3 kΩ in series:
- Rtotal = 6 kΩ, so I = 12 / 6,000 = 2 mA
- V1 = 0.002 × 1,000 = 2 V
- V2 = 0.002 × 2,000 = 4 V
- V3 = 0.002 × 3,000 = 6 V
The drops add up to 12 V, the supply voltage. This is Kirchhoff’s voltage law, and it is a handy check on any series calculation.
Voltage drop in parallel circuits
Resistors in parallel all have the same voltage across them, equal to the voltage across the whole group. To find it, combine the parallel group with the parallel resistor calculator, treat the result as one resistor in the series string here, and read off its drop.
Measuring voltage drop
Set a multimeter to DC volts and touch the probes to both ends of the resistor while the circuit is powered. Unlike resistance measurements, this works with the resistor still in place. If the measured drop is very different from the calculated one, check for a wrong resistor value, a poor connection or an unexpected load.
For a full step-by-step guide, read how to calculate voltage drop across a resistor.
Frequently asked questions
Why does a resistor drop voltage?
Pushing current through a resistance takes energy. The voltage drop is that energy per unit of charge, and it is turned into heat in the resistor.
Does the largest resistor have the largest voltage drop?
In a series circuit, yes. The current is the same through every resistor, so the drop is proportional to the resistance.
What is the difference between voltage and voltage drop?
Voltage is measured between any two points. Voltage drop is the voltage between the two ends of one component, the part of the supply it “uses up”.
More calculators
-
Resistor Color Code Calculator
Decode 3, 4, 5 and 6-band resistors, or find the bands for a value.
-
Parallel Resistor Calculator
Total resistance of up to 20 resistors in parallel.
-
Series Resistor Calculator
Add up resistors in series, in any mix of units.
-
LED Resistor Calculator
Current-limiting resistor, standard value and wattage for LEDs.
-
Ohm's Law Calculator
Enter any two of voltage, current, resistance and power.
-
Voltage Divider Calculator
Output voltage, or the resistor needed for a target voltage.
-
Resistor Power Calculator
Power dissipated in a resistor and the wattage rating to buy.
-
SMD Resistor Code Calculator
Decode 3-digit, 4-digit, R and EIA-96 SMD markings.
-
Standard Resistor Values
Nearest E6 to E192 value for any resistance.