Resistor Power Calculator

Work out the power a resistor dissipates from any two of voltage, current and resistance, and the wattage rating to choose.

Enter any two of voltage across the resistor, current through it and resistance.

V
Power dissipated 810 mW Use a 2 W resistor or larger (at least twice the dissipated power).
Current
90 mA

How to use the resistor power calculator

Enter any two of the voltage across the resistor, the current through it and its resistance. The calculator shows the power turned into heat and recommends a standard rating with a twofold safety margin.

Resistor power formulas

A resistor turns electrical energy into heat. Three versions of the same formula cover every case:

P = V × I
P = I² × R
P = V² / R

Use the voltage across the resistor, not the supply voltage, unless the resistor is the only thing in the circuit. In an LED circuit, for example, the resistor only sees the supply minus the LED’s forward voltage.

Worked examples

  • 9 V across 100 Ω: P = 81 / 100 = 0.81 W. A 1 W resistor would be working near its limit, so choose 2 W.
  • 20 mA through 150 Ω: P = 0.02² × 150 = 0.06 W. Any 1/8 W or 1/4 W resistor is fine.
  • 5 V across 10 Ω: P = 25 / 10 = 2.5 W, more than most hobby resistors can handle. Use a 5 W part, or rethink the design.

Choosing a wattage rating

A resistor’s rating is the most it can dissipate under ideal conditions, usually at 70 °C ambient or below, with free air around it. Real enclosures are warmer and more crowded, so engineers derate. The common rule is to pick a rating at least twice the calculated power. At full rated power a resistor can run well over 100 °C, which is hot enough to burn a finger, discolor a circuit board and shorten the life of nearby parts.

Package Typical rating
0402 SMD 1/16 W (0.063 W)
0603 SMD 1/10 W
0805 SMD 1/8 W
1206 SMD 1/4 W
Small through-hole (about 6 mm long) 1/4 W
Larger through-hole (about 9 mm long) 1/2 W
Wirewound and ceramic power resistors 2 W to 50 W and more

These are typical figures. Ratings vary between manufacturers and series, so check the datasheet.

Signs a resistor is overloaded

Discolored or cracked coating, a burnt smell, a darkened patch on the circuit board, or a value that has drifted well outside its tolerance. A resistor that is too hot to touch comfortably is a warning sign even if it still works.

For a fuller explanation, read resistor power ratings explained.

Frequently asked questions

How do I calculate the power dissipated by a resistor?

Multiply the voltage across it by the current through it. If you know only the current and resistance, use I² × R. If you know only the voltage and resistance, use V² / R.

Can I use a higher wattage resistor than needed?

Yes. A higher rating only means the part is larger and runs cooler. The resistance and circuit behavior are the same.

Can I use two resistors to share the power?

Yes. Two equal resistors in series or in parallel share the power equally, so two 1/2 W resistors can handle about 1 W together.

More calculators